Where are resistors placed to control voltage and current


    Within Tapped Circuits Within Fixed Resistors Within Electrical
    Circuits Within Fixed Symbols
    2. What is the function of a conductor? To permit no motion of a large number of electrons To
    permit no motion oftightly bound electrons To permit the free motion of a large number of electrons To permit the free motion of
    tightly bound electrons
    3. What is a solenoid? Electromagnetic Switch Single Coil Switch Single-pole,
    Double-throw Relay
    4. What is an Ohmmeter? A measuring device that measures difference of potential applied to a current A
    measuring device that reads resistance in ohms A measuring device that measures resistance in current A measuring device that reads tl
    amount of current flowing in a circuit
    5. What source is the clamp tester placed around to measure the magnetic field? Voltage
    Source Current- carrying Conductor Resistive Load Power Source
    6.
    7. Eo293 Figure 6-1.
    8. Refer to the figure above. What is
    the value of R (ohms) in a series circuit if E =50 volts and I= 10 amps? .5 ohms 10 ohms 5 ohms 1 ohm
    9.
    10. Eo29} Figure
    7-1.
    11. Refer to the figure above. What is the total power (Pt) ofthis series circuit? 100 watts 200 watts 50 watts 1,000
    watts
    12.
    13. Eo29} Figure 8-1.
    14. Refer to the figure above. What is the equivalent resistance of five, 100 Ohm – resistors
    connected in parallel? 50 ohms 100 ohms 30 ohms 20 ohms
    15. What are the characteristics of magnetic attraction and
    repulsion? North poles attract North poles, and South poles attract South poles All poles attract each other Unlike poles attract
    each other, and like poles repel each other Strong poles attract, and weak poles repel
    16. What term best defines electrical pressure,
    difference of potential, or electromotive force? Voltage Resistance Current Power
    17. What is the term for the relationship
    of voltage (E), current (I), and resistance (R) in a simple electrical circuit? Resistance Law Voltage Law Current Law Ohm?s
    Law
    18.
    19. Eo29} Figure 12-1.
    20. Refer to the figure above. What is the value of E (volts) if R = 25 ohms and I= 1 amp? 9
    volts 0 volts 250 volts 30 volts
    21.
    22. Eo29} Figure 13-1.
    23. Refer to the figure above. Find the current in a series
    circuit when given the following: R1 = 4 ohms, R2 = 5 ohms, R3 = 2 ohms, R4 = 11 ohms, and Et = 88 volts. 4 amps 7 amps 6 amps
    amps
    24.
    25. Eo29} Figure 14-1.
    26. Refer to the figure above. In a series-parallel circuit, R1 is in series and R2 and R3 are in
    parallel with the source voltage. What is the Rt (total resistance) if given the values of R1 = 10 ohm, R2 = 6 ohms, R3 = 6 ohms? 13
    ohms 360 ohms 10 ohms 20 ohms
    27.
    28. Eo29} Figure 15-1.
    29. Refer to the figure above. In a series-parallel circuit, R1 is
    in series and R2 and R3 are in parallel with the source voltage. What is It ofthe circuit if given the values of Es = 30 volts, R1 = 8
    ohms, R2 = 3 ohms, and R3 = 6 ohms? 30 amps 1.5 amps 3 amps 50 amps
    30. Which ofthe following statements best defines a
    series electrical circuit? An arrangement of electrical devices connected so that the total current must flow through all devices A
    flow of electrons that have more than one path to follow, from positive to negative An arrangement of electrical devices connected so that
    the total voltage must flow through all devices An electrical circuit that prevents current flow
    31. What is the smallest physical
    unit to which an element or compound can be reduced? Water Matter Molecule Atom
    32.
    33. Eo29} Figure 18-1.
    34. Refer to
    the figure above. What is the total voltage (Et) available in this parallel circuit? 0 volts 10 volts 40 volts 160
    volts
    35.
    36. Eo29} Figure 19-1.
    37. Refer to the figure above. What is the total voltage (Et) of two, 24-volt batteries in
    parallel? 24 Volts 12 Volts oVoIts 48 Volts
    38. What would you call the movement of free electrons past a reference
    point? Current Bound Electrons Electron Charge Un-bound Electrons
    39. Which device transfers electrical energy from a primary
    coil to a secondary coil induction? Motor-starter Diode Transformer Relay
    40. Which term best describes the product ofthe
    force known as torque? Pressure Tension Rotation Power
    41.
    42. Eo29} Figure 23-1.
    43. Refer to the figure above. What
    is the value ofl (current) in a series circuit if E = 50 volts and R = 25 ohms? 3 amps .5 amps 2 amps 1 amp
    44. What is the
    missing voltage drop of a 50-volt power source that has known voltage drops of 10 volts, 15 volts, and 20 volts? 6 volts 12 volts 8
    volts 5 volts
    45.
    46. Eo29} Figure 25-1.
    47. Refer to the figure above. In a series circuit, what is the value of Rt if R1 = 9
    Ohms, R2 = 9 ohms, and R3 9 = ohms? 9 ohms 27 ohms 0 ohms 3 ohms
    48. When using a multimeter remove all power from the
    equipment, with the exception of ACIDC circuits being tested, before connecting or disconnecting what component? Power cord Test
    lead Battery Rotary switch
    49. What term best describes the space surrounding a magnet, in which the magnet force
    acts? Magnetic Shielding Magnetic Flux Magnetic Field Lines of Force
    50. Which statement best defines a parallel electrical
    circuit? A circuit having more than one current path connected to a common voltage source A circuit having more than one voltage
    source Two series circuits on top of each other A circuit having one current path connected to a common voltage
    source
    51.
    52. Eo29} Figure 29-1.
    53. Refer to the figure above. What is the total power (Pt) ofthis parallel circuit? 100
    watts 50 watts 40 watts 20 watts
    54.
    55. Eo29} Figure 30-1.
    56. Refer to the figure above. R1, R2, and R3 are three
    resistors in parallel. What is the total current ofthis parallel circuit if given the values of Et = 48v, IR1 = 4a, IR2 = 8a, and IR3
    12a? 12a 4a 24a 8a
    57. What simple rule has been established for finding the direction of magnetic force around a
    current-carrying conductor? Both Right and Left Hand Rule Right Hand Rule Current Flow Rule Left Hand
    Rule
    58.
    59. Eo29} Figure 32-1.
    60. Refer to the figure above. What is the power (P) ofthis circuit? 20 watts 100
    watts 10 watts 5 watts
    61. What type of switch has an onloff position with one pole and one contact? Single-pole, Double-throw
    Switch Double-pole, Single-throw Switch Single-pole, Single-throw Switch Double-pole, Double-throw Switch
    62. What is the simplest
    protective device for an electric circuit? Motor-starter Ampere Breaker Fuse
    63.
    64. Eo29} Figure 35-1.
    65. Refer to
    the figure above. What is the total power (Pt) ofthis series-parallel circuit? 180 watts 150 watts 50 watts 100
    watts
    66. Which ofthe following statements best defines a series-parallel electrical circuit? A series-parallel circuit has the
    same current (I) in all parts ofthe circuit A series-parallel circuit has at least three resistive components that are connected in both
    parallel and series A series-parallel circuit has the same voltage (E) in all parts ofthe circuit A series-parallel circuit has at
    least two resistive components that are connected in both parallel and series
    67. What electrical device stores a
    charge? Capacitor Circuit Electron Resistor





                                                                                                                                      Order Now